Contact us
Welcome to call
13715491170
Leave us a messageMessage
Technical Support
Your location:Home ＞ News ＞ Technical SupportPC board installation precautions
Announcer:Haosu Time:2017-03-14
(1) The installation of the organizers must be printed on the protective film printed on the notes and notes to understand clearly, and explain to the operator, with particular attention to which side of the standard. Do not be wrong.
(2) Before installation, shall not peel off the protective film, only along the board edge of the protective film will be lifted about 50mm, after the installation immediately peel off the protective film, such as the need to continue to protect the board, then first peel off the film, Protective film.
(3) The sealing material of the viscous material should not damage the PC sunshine board.
(4) Seal tape should have good weather resistance, and should not lose viscosity and mechanical strength for a long time.
(5) Do not polish or clean the sun with strong alkali plate, do not use a hard brush to wipe the surface, so as to avoid the phenomenon of nap
(2) Before installation, shall not peel off the protective film, only along the board edge of the protective film will be lifted about 50mm, after the installation immediately peel off the protective film, such as the need to continue to protect the board, then first peel off the film, Protective film.
(3) The sealing material of the viscous material should not damage the PC sunshine board.
(4) Seal tape should have good weather resistance, and should not lose viscosity and mechanical strength for a long time.
(5) Do not polish or clean the sun with strong alkali plate, do not use a hard brush to wipe the surface, so as to avoid the phenomenon of nap
Related news
- Method for mounting PC board2017-03-14
- Sealing technology of PC board2017-03-14
- Storage and transportation of PC plates2017-03-14
- Requirements for cold bending of PC boar…2017-03-14
- PC plate material properties2017-03-14
